Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
08-29-2021, 12:40 PM | #1 | |
AF Newbie
Join Date: Nov 2005
Location: Burlington, Iowa
Posts: 85
Thanks: 16
Thanked 1 Time in 1 Post
|
2012 RAM Trailer controller hookup.
I'm in the process of installing a Tekoncha trailor brake controller. During preliminary testing prior hooking up the module I find 12V on break switch wire. Is this a high impedance voltage and will drop when I hook up the module. If not, where is this wire picking up the brake signal. I cant find it on the brake pedal switch. Thanks for any help.
|
|
11-25-2021, 11:05 PM | #2 | |
AF Newbie
Thread starter
Join Date: Nov 2005
Location: Burlington, Iowa
Posts: 85
Thanks: 16
Thanked 1 Time in 1 Post
|
Re: 2012 RAM Trailer controller hookup.
I'm late responding to my own post. Further testing reveled the following. I finally found my third brake lite was also on the low side of the brake switch but it was bad. An open circuit
reading with a high impedance meter read the hot side of the brake switch. Replace the third brake lite bulb and problem solved. |
|
|
POST REPLY TO THIS THREAD |
|
|