 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
| General news, articles, other. |
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
09-14-2004, 12:21 AM
|
#1 | |
|
AF Newbie
Join Date: Sep 2004
Location: memphis, Tennessee
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
how to replace crankshaft pulley on G20
The crankshaft pulley broke on my 91 G20. I have order a replacement from the dealer. But, I am unable to figure out have to get the broke one off.
Thanks Robert |
|
|
|
|
09-14-2004, 10:09 PM
|
#2 | |
|
AF Newbie
Join Date: Jan 2003
Location: murray, Utah
Posts: 7
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: how to replace crankshaft pulley on G20
pretty simple there is a bolt holding it to the crank shaft, its a 26 or 27mm bolt, just take an impact gun and buss it off, on the side you will notice that there are two holes that have threads in them, all you have to do is get some bolts i believe they are 6mmx1.25 or 1.50 and thread them in and as you tighten them down they will Push the pulley off and you can install the new one.
make sure that you remove your belts or else you will have some potential problems regards joe a.k.a WiggY also for the price you got the crank pulley you may have been able to get the two pulley underdrive set from unorthodox racing (jgycustoms.com) regards joe a.k.a WiGgY
__________________
"I can picture you in heaven with a BLUNT and a BREW" -- 2pac Some one should by my corvette pics are <a href="http://www.cu.quik.com/joe187h/vet/corvette.html"</a>HERE</a> |
|
|
|
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
