Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
240Z | 260Z| 280Z | 300ZX (Past Z Cars) The original Z cars - ones that started it all. |
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
10-19-2009, 11:35 AM | #1 | |
AF Newbie
Join Date: Oct 2009
Location: winnipeg
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
Whats wrong with my 1990 300zx?
hi, i am new to the forums, i just bought 1990 300zx with 72k on it (km not m). the clutch was slipping when i got it and a few days ago just completely cut out. when i put it into gear and try to drive it just revs. Would that be my clutch that needs to be replaced? or one of the cylinders?
also. my car sometimes shut off when driving (more common after driving harder) (car has electronic boost controller up to 16psi but only ran at about 6-12 , 2 1/2 inch dual exhaust) Please help, whats wrong with my z so i can get it back on the road but have a little knowledge so the repair shops dont try to walk all over me! |
|
01-13-2010, 08:30 PM | #2 | |
AF Newbie
|
Re: Whats wrong with my 1990 300zx?
First things first ,, with 70 k on your car.. When did it have the timing belt replaced if it even was?
Second, if it wasn't or hasn't been replaced .. DO NOT DRIVE IT anymore until the belt is repalced.. Or you'll trash the engine..! I've seen the belts snap with 70k on them especially if you have a TT. What's a $30 belt compared to an engine replacement Last edited by txq45; 02-03-2010 at 07:34 AM. |
|
02-02-2010, 11:53 PM | #3 | ||
AF Regular
Join Date: Aug 2006
Location: Jacksonville, Florida
Posts: 169
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Whats wrong with my 1990 300zx?
Quote:
Sounds liek your in safety boost... so run your ecu codes and that will be a big lead. But for the clutch issue... does your pedal feel normal? It may be time for a new clutch. It shuttng off is most like due to a vaccum leak. do a boost leak test to find out. or the ecu might tell you.
__________________
GT2560r's, Nismo 615cc, ARP Head Studs, UD Pulley, SouthBend Stage5 clutch, 60mm TB's, Ash-spec Tune, Specialty Z 3" DPs, HKS intake, Energy Suspension, z1 Drive Shaft,E-fan, Port/Polished heads, AMS Manifolds, HKS SSQV BOVs, Howe Radiator, RPS segmented LW flywheel, UR OverDrive waterpump pulley, Billion Thermo, z1 silicone hoses, Stillen gauge pod w/autometers, D&S rotors all around |
||
|
POST REPLY TO THIS THREAD |
|
|