Programming Remote

[Theresa40]

Originally Posted by wafrederick

The only way to program one of those is go to the dealer and has to be programed with Chrysler's scan tool DRB III.

Can I purchase the remotes on ebay and then have the dealer program one remote and I program the other? Dealer quoted one remote purchase of $50.00 and to program one remote $50.00.

[Onblsht]

If you have the COUPE you can program with the instructions I provided a few posts back. If you have the Sedan, and no current WORKING remotes, you must have them programmed at the dealer.

[snakelda]

Originally Posted by Onblsht

Status COUPE ONLY...

1. Locate the Data Line Connector (DLC) underneath the driver's side dashboard. The DLC is typically located either to the left or the right of the steering column base. Notice how the DLC is tapered on both ends: you will be working on the wider row of cavities
2. Insert keys in Ignition and leave in the off position.
3. Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Line Connector (DLC) terminal 1 to terminal 4 with a suitable jumper wire, leave the jumper wire connected throughout the programming procedure). Make sure you know which terminals are 1 and 4.
4. Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. (Note) The doors will automatically lock and unlock once at this time indicating that the system is in the programming mode.
5. Press either the lock or unlock button on the transmitter to be registered three times within 10 seconds. Upon successful
programming, the door will lock and unlock once.
6. Repeat step 5, with any other remotes to be programmed (up to four remotes) (including any existing remotes), within one minute. After completing each programming, the doors will lock and unlock once.
7. Disconnect the programming wire and remove the keys from the
ignition.

OMG!!Thank YOU!I kept googling for this and finally found it!!!!!!MEGA PROPZ!!!

[Rhonda D]

Originally Posted by jsavant

I bought a remote from EBAY and these are the instructions that came with it. I will need to e-mail them to you as there is a picture.
Sorry they do not seem to cover models other than 2000 and up.

Hi, I just registered and I desperately need the programming directions for a remote without an existing one. I am going to buy one from E-Bay, but they all say you must have one to program one. The one I'm buying gave me this site.

Thanks

[moparman91]

i bought a o1 stratus couple it came with onley on set of keys and i lost them 4 whelling i was thinking bout buy another one can it be reprogramed

[akepps05]

Originally Posted by jsavant

I have recently learned how to program the remote, if you need this info don't bother paying for it. You can program up to 4 remotes if you should need that many. Post here and I can let you know how.

jsav-went to the dealership to get the remote programmed......they wanted a c-note. Can you help me ?
that's for a 2005 dodge stratus (4 dr sedan)

[Daniel Paniagua]

Originally Posted by jsavant

I have recently learned how to program the remote, if you need this info don't bother paying for it. You can program up to 4 remotes if you should need that many. Post here and I can let you know how.

I could you help me to program a Dodge Stratus 01 keyless entry?

I lost my previous keyless entry so I have one that I bough from ebay.

Thanks.

[docrocket]

I have a 2001 Jeep Grand Cherokee and lost the Keyless Remote. I purchased two off Ebay but would like to know how to program them.

Thanks for your help!
Dan

[starcly]

Iam about to purchase a new remote for my car....You said you know how to program the new one, I would appreciate any help you may have.

Thanks!

[peeweegal2004]

Originally Posted by jsavant

I have recently learned how to program the remote, if you need this info don't bother paying for it. You can program up to 4 remotes if you should need that many. Post here and I can let you know how.

I recently bought a remote for this car i do not know if it had a remote prior to being sold so can you help me with the programming and it is a 03 stratus coupe.

Thank you
Brenda

[camaron03]

Originally Posted by jsavant

I have recently learned how to program the remote, if you need this info don't bother paying for it. You can program up to 4 remotes if you should need that many. Post here and I can let you know how.

I have two remotes that I need to program can you tell me how. camaron03@hotmail.com

[binomnew]

Hello I have a 2002 stratus 4 door and I'm going to buy a remote control, could you help me with some information about how to program it?

Thanks in advance

[Rae72106]

Hi, I have a 1999 Chrysler concorde lxi, I want to buy a remote for it, but I don't have an existing remote, Can someone PLEASE help me program it? I really don't and cant afford to take it to the dealer for $90. Thanks!

[Onblsht]

Hello -

You will need at least 1 working remote to program the remotes yourself.

Without a working remote, you will need to bring the vehicle and the remote(s) you want to program to your local locksmith or dealer so they can program with a scantool.

[tgato1970]

is there away to program a remote on a 2001 dodge stratus se i don't have no remotes and i want to purchase on thanks