Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
04-16-2009, 02:07 PM | #1 | |
AF Newbie
Join Date: Sep 2007
Location: Dixon, Illinois
Posts: 45
Thanks: 0
Thanked 0 Times in 0 Posts
|
02 Intrepid 2.7L swap 2.7L seabring
ok so I found a 2.7l engine for my intrepid out of a Seabring i switched the pulleys etc got the engine in everything hooked up. I got her fired up and when u give it gas its like it has a rev limiter messing with it U hit the throttle and u get no rpms it just surges up and down its throwing out these codes
P0344 P0108 P0016 P0113 I changed all my sensors from my 2.7 out of my intrepid and put them on the seabring block ne suggestions would be nice the 2.7l i put in it came out of a 98 seabring i used block and heads only i was reading that i may have had too change the cam gear is this true? i didnt think i would need too since they are both 2.7l blocks |
|
05-02-2009, 05:29 PM | #2 | |
AF Regular
Join Date: Mar 2006
Location: Pekin, Illinois
Posts: 140
Thanks: 1
Thanked 0 Times in 0 Posts
|
Re: 02 Intrepid 2.7L swap 2.7L seabring
P0344 - Camshaft Position Sensor Circuit Intermittent
P0108 - Manifold Absolute Pressure/Barometric Pressure Circuit High Input P0016 - Crankshaft/Camshaft out of alignment P0113 - Intake Air Temperature Circuit High Input If the cam position sensor senses something on the cam gear, then your Intrepid cam sensor may not get a proper signal from the sebring cam gear. It looks like P0344 and P0016 could point to this. If you have the plug for it you could try the Sebring sensor, but I don't know if it would work or not. Hope this helps. Dustin |
|
|
POST REPLY TO THIS THREAD |
|
|