 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
12-02-2004, 09:55 PM
|
#1 | |
|
AF Newbie
Join Date: Dec 2004
Location: keller, Texas
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
93 Jeep Grand Cherokee 4.0 Crank Position Sensor?
93 Cherokee 4.ol Will Not Start, Ran Fine Then Suddenly Will Not Start. Checked Plugs, Wires, Coil, Cap, Rotor, Fuel Pump, Fuel Filter, Fuel Pressure 42psi., Good Spark From Coil And All Plugs. New Battery, Security System Not An Issue. After Reading This Forum I May Be Discovering A Crank Position Sensor Problem?? Any Ideas..when I Crank The Engine There Is No Rpm Indication On The Tach. I Have Spark, Good Fuel Pressure And Some Air, But No Bang?? Anyone Know Exactly Where The Cps Is In The Engine Compartment. Should I Be Looking For The Crank Or Cam Position Sensor.
Any Help Would Be Greatly Appreciated. Thanks Rick |
|
|
|
|
12-02-2004, 10:31 PM
|
#2 | |
|
AF Newbie
Join Date: Oct 2004
Location: las vegas, Nevada
Posts: 23
Thanks: 1
Thanked 0 Times in 0 Posts
|
the crank shaft position sensor is attached to the transmission bell housing.
|
|
|
|
|
|
12-03-2004, 06:33 AM
|
#3 | |
|
AF Regular
 
Join Date: Nov 2004
Location: woodstock, Georgia
Posts: 382
Thanks: 0
Thanked 0 Times in 0 Posts
|
go to www.autozone.com they have the procedures there to test the c.p.s. let us know how things go!
|
|
|
|
|
|
12-05-2004, 04:23 AM
|
#4 | |
|
AF Enthusiast
Join Date: Jul 2004
Location: Phoenix, Arizona
Posts: 647
Thanks: 0
Thanked 0 Times in 0 Posts
|
There is a ballast resistor onthe drivers fender. Try running a jumper wire across the terminals or hold the throttle wide open and the try to start if it does the resisitor is bad.Fuel pump ballast resistor, fuction is to keep the fuel pump noise down. Since you have spark i dont think it is the CPS.
|
|
|
|
|
|
12-05-2004, 09:12 AM
|
#5 | ||
|
AF Enthusiast
 Join Date: Dec 2003
Location: Brentwood, Ohio
Posts: 864
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: 93 Jeep Grand Cherokee 4.0 Crank Position Sensor?
Quote:
Did you check for spark at the coil wire or the plug wires. Try giving it a shot of starting fluid. The crankshaft position sensor is located on the drivers side on the bellhousing. if you need picture i can send one. Holler jeepman600@aol.com Dale  |
||
|
|
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
