Auto to Manual - Reverse lights don't work!

Yeah its me again. Solved the speed sensor problem, but now I've got another.

When I shift into reverse the reverse lights don't come on.

Am I missing something?

Yeah its me again. Solved the speed sensor problem, but now I've got another.

When I shift into reverse the reverse lights don't come on.

Am I missing something?

Did you attach the reverse light harness?

This is probably a stupid question, but where is that located?

You have a N/T right? If you open the hood and look right at the front of the tranny, it sits right in front.

Best pic I can find really. You can see the connector for it on the far right
http://www.dsmtuners.com/forums/attachments/420a-bolt-tech/81969d1207371626-420a-engine-swap-tranny-1.gif

Yeah its non-turbo

I've found the connector, but what do wires on the connector connect to?

The one write up I found on 2gnt says to wire the Reverse Sensor to the Park/Neutral switch. If thats the case which one of the plugs are the Park/Neutral switch?

If the car was auto before then it's not going to have the connector that.
Not sure on the new connector though. Sorry dude.

Never mind man, I found the problem, Reverse lights are working.

Thanks though.

What was the problem?

It was like the write up on 2Gnt said.

The two wires on the Reverse sensor had to be wired to the Park/Neutral Connector.

The car that was used in the write up was for a 95, which uses two separate computers, one for the trans and one for the motor. 95 is the only year where they did this for some reason. 96-99 uses just one computer, and on my car (96+) the Park/Neutral connector and Transaxle range switch connector are both one switch, where as the 95's are two separate connectors.

It took me awhile after looking over the plugs to figure that out.

But now the reverse lights are working as they should.

Cool cool. Glad it's working now.