ANOTHER QUESTION! (exhaust)

If I wanted a muffler shop to run straight pipe off of the manifold with a gaudi tip and a muffler without a cat (we dont check for emissions here) how much would it cost opposed to getting a catback and highflow cat off of a website...

If I wanted a muffler shop to run straight pipe off of the manifold with a gaudi tip and a muffler without a cat (we dont check for emissions here) how much would it cost opposed to getting a catback and highflow cat off of a website...


not much it should be fairly straigt all they need to do is cut it to length, bend it a bit flange it weld on some hangers, bolt on the muffler and hange the pipe. 2 hours work max. not sure about a price though no more than $150-200 without muffler!

Thankya Noshun, I will go check the shops out after enough snow melts to the point where I can get out of the driveway. My dad is struggling to get out in 4-high on his pickup.

Also depends on what size pipe and wheather or not its stainless steel pipe. I'd say about a 100-150 more than noshun said for stainless piping.

Also depends on what size pipe and wheather or not its stainless steel pipe. I'd say about a 100-150 more than noshun said for stainless piping. that a lot for one peice of pipe!

Usually takes sections, atleast when i have mine done it will be.

Usually takes sections, atleast when i have mine done it will be.


Depends how they make it. sections should be cheaper as they can actually use std size ready bent tubs for that, cutom bending is more expensive, but a hand mandrel isn't TOO expensive!