V8 Conversion Front Coil Springs Needed

1988 S-10 Blazer
Looking to find replacement front coil springs other
than OEM HD's [4.3L w/AC] adding aprox 200lbs to front
not intrested in air/spacers, ect, somebody has already done
this, what replacement coil used based on coil dimensions, not/
incl free standing height. donot want to lower/raise vehicle oem
height.
So far i have one source working with them midwest spring co.
Iowa. 1 [800] 424-0244, they purchased Landrum Spring Co.
Only mgr Auto/Truck coils. still waiting for answer from them.
Looking for other solutions/sources.
Hopefully somebody can help out\Thanks
Otherwise, project is comming along fine, Frame Off Restro,
Frame Expoxy Primered, Shot w/Truck Bed Liner Spray and all
related parts, poloy bushing entire, firewall ECM Mod's completed,
moved ECM, Ect to Drivers Side Under Brake Booster Area.
Rear-End Bolt 1999 Yukon SUV 8.6 Cut-Down, Eaton 35 Spline w/
mosier axels, People oare out of Jackson, NJ.
Get some coils, body goes back on, start setting engine.
JLDrescher
Cosmo222@adelphia.net
Thanks Again

Try this site http://www.cheaptruckparts.com/subcat.asp?338

Try this site http://www.cheaptruckparts.com/subcat.asp?338
Thanks for response, noticed adjustable/lift coils for front.
somebody i'am sure has already replaced OEM with another
vehicle coil that works for this application/situation.
Did like the rear air bagsat site, will be re-installing trailer hitch, so
rear sag willl need air bag assist when loaded, thanks.
Still looking.

I'm getting a custom made bumper for my blazer that has a class 3 hitch built right in for less than the hitch would cost me alone.

I do have welder friends, one whom is doing the job, but it should be reasonable for everyone to get made up. It's only some round pipes, and some box steel

I'm getting a custom made bumper for my blazer that has a class 3 hitch built right in for less than the hitch would cost me alone.

I do have welder friends, one whom is doing the job, but it should be reasonable for everyone to get made up. It's only some round pipes, and some box steel

Call [770] 606-8871 now let ring, caller ID here, willl call u back, thanks Jeff

Call [770] 606-8871 now let ring, caller ID here, willl call u back, thanks Jeff

Sorry Jeff I'd rather just send you a photo of it. What I didn't say is it took me 6 months to get my welder to make it up, and I'm just getting ready to leave on a 1 month holiday so I don't have much time for dealing with him. He's good but semi-retired, and only does what he wants, when he wants

You should really be able to get any local welder to do it.

If your stuck I'll see what I can do though

Hi Jeff If you want I'll be on line tonight, around 11 west coast time, and my chat line in MSN is
siu681@hotmail.com

or in Yahoo.

siu681

People are sleeping in this house then, so I shouldn't really talk on the phone then.

I might even be on line as early as 10, when I can have my mic hooked up

Later then