Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys
Go Back   Automotive Forums .com Car Chat > Pontiac > General Discussion
Register FAQ Community Arcade Calendar
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools
Old 11-21-2022, 08:35 PM   #1
crazydriverz
AF Regular
 
Join Date: Nov 2005
Location: lansing, Michigan
Posts: 111
Thanks: 10
Thanked 1 Time in 1 Post
2009 G6 2.4li engine

crazy deal here. i had to replace my front passenger side cv axle. so as needed, i did so. but then three times the new cv axle popped out. leaving me stranded. what can i do to fix this. need help so bad
crazydriverz is offline   Reply With Quote
Old 11-22-2022, 08:59 AM   #2
Blue Bowtie
Registered Offender
 
Blue Bowtie's Avatar
 
Join Date: Mar 2006
Location: Rural
Posts: 6,518
Thanks: 6
Thanked 341 Times in 336 Posts
Re: 2009 G6 2.4li engine

There is a detent ring which clips into a groove in the differential output shaft. The ring on the replacement axle or the output shaft groove could be damaged. Are you certain the ring was fully engaged when the half shaft was installed? Some of them can require a fairly sharp blow around the inner joint to get the axle to fully seat.

It is also possible that if the replacement axle was an aftermarket piece, it was manufactured incorrectly.
__________________
Permanent seat assignment on the Group W bench...
Automotive Forums Survival Guide
Blue Bowtie is offline   Reply With Quote
The Following 2 Users Say Thank You to Blue Bowtie For This Useful Post:
crazydriverz (11-26-2022)
Old 11-26-2022, 01:45 PM   #3
crazydriverz
AF Regular
Thread starter
 
Join Date: Nov 2005
Location: lansing, Michigan
Posts: 111
Thanks: 10
Thanked 1 Time in 1 Post
Re: 2009 G6 2.4li engine

well after some looking into i pulled off the ring. its attached to the trans. so the cv axle end that goes into the trans is a female end. so after looking at the ring. i noticed the shoulders are very rounded and dented up. so im going to replace it. is it a part i can pick up from autozone
crazydriverz is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums .com Car Chat > Pontiac > General Discussion


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 11:38 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts