Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
04-24-2007, 11:46 PM | #1 | |
AF Newbie
Join Date: Apr 2007
Location: Margate
Posts: 2
Thanks: 0
Thanked 1 Time in 1 Post
|
Daihatsu charade ring gaps
Hi, does anyone know the ring gaps for an 89 charade 1L G 100?
|
|
The Following User Says Thank You to undercoverbrother1 For This Useful Post: |
Atozer (05-02-2011)
|
06-15-2023, 11:39 PM | #2 | |
AF Newbie
Join Date: Sep 2022
Location: Tainan
Posts: 55
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Daihatsu charade ring gaps
0) Checking piston ring end gap
After the cylinder has been checked or reconditioned, insert the piston ring into the cylinder bore down to a point about 110 mm (4.3 inches) measured from the cylinder head gasket attaching surface. Then, meas- ure the piston ring end gap. NOTE: Apply engine oil to the piston ring before inserting it. [CB-80 engine] Compression ring No.1 0.35 - 0.70 rnm (0.014 - 0.028 inch) Compression ring No.2 0.28 - 0.70 mm (0.01 1 - 0.028 inch) Oil ring 0.20 - 1.10 rnm (0.008 - 0.043 inch) End gap If the end gap exceeds the specified limit, replace piston ring as a set. Piston ring [CB-23 & CB-61 engines] Fig. 5-255 Compression ring No.1 0.20 - 0.70 mrn (0.079 - 0.028 inch) Compression ring No.2 0.20 - 0.70 mm (0.079 - 0.028 inch) Oil ring 0.20 - 1.10 mm (0.079 - 0.043 inch) |
|
|
POST REPLY TO THIS THREAD |
Thread Tools | |
|
|