Just one more Gallardo, boring i think :)

[Lurchio]

Brakes look awesome - not too clean at all!

[kunta]

Nice paint job. and I think you have good camera 'cause pics are very clear and fine.

[tonioseven]

Extremely clean build!! Very good stuff!!

[Baxik]

Help needed...

I have photo etch set for Gallardo from Acu-Steon, but instruction only in Japan

What is this?

[HotRodDreamer]

great job so far, i love the brakes! im not an expert on PE parts, but my guesses are: 1. some sort of handle on the center console possibly, i think the Murci has somethin like that; 2. looks a lot like it could be the interior door handles; 3. parts for a scale harness if you wanted to make one possibly; 4. lookin like somethin else with the seatbelt system but idk. sorry if that was no help at all, but im sure you'll figure it out and it'll look great

[bvia]

Howdy.

#3 are the racing harness bolt down plates used to attach the ends of the seatbelts to the floor of the car. The small hole get's a bolt that travels through the car's underbody and the opposite end's opening is where the seatbelt material loops through and is then sewn shut. On a 4-point harness you would have 2 that attached the lap belts to the floor beside your hips and 2 that attached the shoulder belts to the rear floor.

hth,
Bill

[MidMazar]

Great progress, the interior is going to look amazing, my guess on the pe parts is, # 2 are some sort of door handles, and thats pretty much all that i think i know.

[A_C]

I found something new about parts 2 & 3. The instruction says that they are "ABC plate". From this pic (http://www.kldconcept.com/l140/sg04/...o04%20(33).JPG), they looks much very like the pedals. So parts 3 must for clutch & brake. But still not sure where part 2 goes to...
Hope this help.

[Baxik]

Originally Posted by A_C

I found something new about parts 2 & 3. The instruction says that they are "ABC plate". From this pic they looks much very like the pedals. So parts 3 must for clutch & brake. But still not sure where part 2 goes to...
Hope this help.

Thanks!!!!

Number 1 - pedal for e-gear version.
Number 2 - for manual gearbox. Gotcha!

[Baxik]

Engine finished... Some wires added

[Veyron]

Looks yummy!

[Captain Mark]

Damn I like that blue you've chosen!

[DukeMan]

Ha! Boring my ass, this is awesome everything looks so clean. I love the Sapphire blue, very nice flip color. Once you have cleared the body, may I ask for a pic that shows the "shift" in the paint a bit? Overall looking very good, keep at it dude!

[Baxik]

Originally Posted by DukeMan

Ha! Boring my ass, this is awesome everything looks so clean. I love the Sapphire blue, very nice flip color. Once you have cleared the body, may I ask for a pic that shows the "shift" in the paint a bit? Overall looking very good, keep at it dude!

Thanks
Of course i'll try to mark this color shift on finished model.
It depends of light angle.

[DukeMan]

Thanks man, I know just how hard this color is to capture on a photo, it´s visible a little bit on the hood/trunk and on the roof. Now get back to the modelling desk and finish this thing up ´cus I want to see it finished!