jdm b16a3 184 whp 128 tq with just bolt ons ??

[Kven]

i think omniman did it(200hp B16) with a ~9000rpm redline; rebuilt bottom end(with stock parts), and a tricked out head(includes head work+cams, etc.)and hondata s100.

[civickiller]

no way he can hit 200whp with the mods you listed there

[S13wanabe]

DH Racing holds a record using all Honda parts with port & polish work getting 189whp with a stock bottom end b16. They put in CTR cams and ported and polished head intake manifold, throttle body and I'm sure exhaust manifold.

[Kven]

Originally Posted by civickiller

no way he can hit 200whp with the mods you listed there

go on rocket motorsport's forum. they have a video of the build and dyno. note: it was dynoed at trackmasters(by bubba, the guy that built leslie durst's crx), and they said it was making more than 200hp because the trackmasters dyno reads lower than the other dynos.


heres a quote from the website:

The parts were:
2 sets of cams , M24x/RM m22/dynamic stg A's
valve springs, port flow
titanium retainers, RM
action clutch, 6 puck
8# flywheel
fpr reg and gauge, trackmasters/ef-1
oem :gasket set,pistons, rings, rods,bearings: bert-o gettel acura
adj cam gears , tweakmeister
3.077 first gear
4.785 final drive
type-r LSD
mildly ported cylinder head, port flow (tom cam up with a special valve job just for this motor, b16a)
chipped ecu and adapter harness, pgmfi.com
the exhaust and throttle body will be in on monday accordinglydone.com
$40 from aussieb20vtec, this will go towards the drag strip entry next week.
310 rc engineering injectors
high compression inconel valves, dynamic autosports

[civickiller]

i dont see it on there, link plz

[Kven]

video: http://m24x.zeroforum.com/zerothread?id=1473&page=1

the parts: http://m24x.zeroforum.com/zerothread?id=2580