-
Grand Future Air Dried Beef Dog Food

Carnivore Diet for Dogs

Air Dried Dog Food | Real Beef
Go Back   Automotive Forums Car Chat > Pontiac > Grand AM
Register FAQ Community
Reply Show Printable Version Show Printable Version | Subscription Subscribe to this Thread
 
Thread Tools
  #1  
Old 03-26-2005, 03:27 AM
Kidlex01 Kidlex01 is offline
AF Regular
 
Join Date: Jun 2004
Posts: 166
Thanks: 0
Thanked 0 Times in 0 Posts
changing plugs....

so how do i change the spark plugs on a 2001 GA 2.4l, how many spark plugs are they and how do you change them?
Reply With Quote
  #2  
Old 03-26-2005, 06:12 AM
Hoags's Avatar
Hoags Hoags is offline
AF Enthusiast
 
Join Date: Jan 2005
Posts: 905
Thanks: 0
Thanked 0 Times in 0 Posts
Re: changing plugs....

You need 4 spark plugs. They are located under the cover on the top of the engine. Remove the 4 bolts (13mm) on the cover and carefully unplug the harness on the end of the cover to your right. Pull the cover straight up (you will have some resistance). Before removing the plugs blow out any dirt and debris so that it can not fall into the engine with the plugs removed. Then remove the plugs, I remove and replace one plug at a time. After all 4 plugs have been replaced carefully put the cover back in place making sure the plug wires are in position. Install the 4 bolts and plug in the wire harness.
NOTE: You may want to replace the spark plug wires while you have it unassembled. About $20.00 at a parts store.
Also, do not over tighten the plugs or the bolts on the cover.
About a 20 minute job. if that.

Good luck,
Reply With Quote
  #3  
Old 03-27-2005, 07:05 AM
Knifeblade Knifeblade is offline
AF Enthusiast
 
Join Date: Nov 2004
Posts: 2,220
Thanks: 0
Thanked 0 Times in 0 Posts
Re: changing plugs....

don't forget the correct plug gap. Should be around .045, but I not positive on that spec. for your engine year.

Your friendly Hoag stalker, lol.

Tam
Reply With Quote
  #4  
Old 03-27-2005, 08:27 AM
Hoags's Avatar
Hoags Hoags is offline
AF Enthusiast
 
Join Date: Jan 2005
Posts: 905
Thanks: 0
Thanked 0 Times in 0 Posts
Re: changing plugs....

Hey, Knife let me run this by you...When I picked up plugs last week, I bought platinum plugs and the counter guy told me not to re-gap the plugs because he plat. coating on the tip can crack and could cause the plugs to foul out or ware out sooner. What do you think?
Reply With Quote
  #5  
Old 03-28-2005, 08:11 AM
tightwad tightwad is offline
AF Newbie
 
Join Date: Mar 2005
Posts: 47
Thanks: 0
Thanked 0 Times in 0 Posts
Re: changing plugs....

What kind of platinum plugs did you buy? Stay away from Bosch plugs. Use AC Delco original plugs only.

He was right, if you use a ramp guage. If you use a wire guage, or feeler guage, you should be ok.
Reply With Quote
  #6  
Old 03-28-2005, 11:26 AM
Hoags's Avatar
Hoags Hoags is offline
AF Enthusiast
 
Join Date: Jan 2005
Posts: 905
Thanks: 0
Thanked 0 Times in 0 Posts
Re: changing plugs....

Hey Tightwad,

Thanks for the info. The guy sold me Motorcraft plugs, he said that they were better than the A/C Delco, I'm not sure about that but I can say that the GAGT is really running great (knock on wood) I have'nt had this kind of power in a long time. May the plugs or the injector cleaning it just had. We'll see how these plugs hold up, I plan on pulling them at about 5,000 mi to check the condition.
Reply With Quote
  #7  
Old 03-28-2005, 11:35 AM
tightwad tightwad is offline
AF Newbie
 
Join Date: Mar 2005
Posts: 47
Thanks: 0
Thanked 0 Times in 0 Posts
Re: changing plugs....

Motorcraft plugs I believe are actually Autolite. Not bad plugs, but Delcos are OEM. I like to run OEM where possible.
Reply With Quote
  #8  
Old 03-28-2005, 11:55 AM
Hoags's Avatar
Hoags Hoags is offline
AF Enthusiast
 
Join Date: Jan 2005
Posts: 905
Thanks: 0
Thanked 0 Times in 0 Posts
Re: changing plugs....

I think you're correct. Autolite. I'm going to run then for a while and see how it goes.
Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums Car Chat > Pontiac > Grand AM


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 06:35 PM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts