|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Register | FAQ | Social Groups |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
06-25-2009, 07:58 PM
|
|||
|
|||
|
'98 Jimmy front axle question
I replaced both front bearing/hub assemblies. Everything sounds and rides nice.
BUT, I noticed that axle threads protrude from axle nut about 1 inch on one side, and only about 1/2 inch on other. The axle actually hits the back of hub cap on one side, allowing cap to rock. The axle does go live in 4WD. 3 hub assembly bolts tightened, both axle (36mm) nuts w/washers torqued to specs....what gives? Why would one side stick out so much more than other. I'm puzzled and a little scared. Thanks, -Dave [email protected] 
|
|
|
POST REPLY TO THIS THREAD |
 |
| Thread Tools | |
|
|
