|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Register | FAQ | Social Groups |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
04-30-2005, 01:04 PM
|
|||
|
|||
|
94 YJ wont start
ive got a 94 yj renegade that wont start. It has a new starter, battery and exhaust system. It will crank but wont turn over and fire. Ive been researching a bit and the crankshaft position sensor seems like a popular culprit... if it is, how easy/hard is it to install and if anyone has any pointers on the install any help would be appreciated. Thanks
|
|
#2
05-02-2005, 11:16 AM
|
|||
|
|||
|
The CPS should be on the top of the bell housing. Or towards the d/s of the bell. It's not too tough to remove, there isn't a lot of space between the bell and the firewall. Have fun
__________________
1995 Jeep Wrangler 3 1/2" lift 33x12.50 tires 4.5L stroked I-6 Bored throttle body & Cold Air Intake Jet Chip Stage 2 Jet Thermostat Colorado Off Road Rig!!!
|
|
|
POST REPLY TO THIS THREAD |
 |
| Thread Tools | |
|
|
