|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Register | FAQ | Social Groups | |||||||||||||||||||||||||
| Car Modeling Share your passion for car modeling here! Includes sub-forum for "in progress" and "completed" vehicles. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
10-25-2017, 07:27 AM
|
|||
|
|||
|
3D printing rear end?
Hi
I am working on a two beautiful Airtrax Ferrari 500 Superfast and 330 2+2 resin kits, I'm looking to see if anyone knows of a 3D print of an appropriate rear end/axle. The kits are great but need some elements from a fujimi 250 gto, I have wire wheels but need a solution for rear suspension and diff. Regards Dave N 
|
|
#4
11-02-2017, 04:58 AM
|
|||
|
|||
|
Re: 3D printing rear end?
Vinc, you may be right but I have a 250 SWB kit so I've tried casting the rear end & suspension with Milliput, after a couple of goes it looks okay.
|
| The Following User Says Thank You to DaveN For This Useful Post: | ||
Vinc (11-02-2017)
| ||
|
|
POST REPLY TO THIS THREAD |
 |
| Thread Tools | |
|
|
