|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Register | FAQ | Social Groups |
![]() |
Show Printable Version |
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
|
|||
|
|||
|
Stalling Problem
Last week my 95 Wrangler 2.5 died. At first I thought fuel pump. I removed the pump and found that the wires for the pump had been pinched and were corroded and one had broken. I spliced the wires with a new section, soldered and shrink tubed them. Jeep ran fine for 2 days and then quit again. This time after a few minutes, fired up again. Did this a few times so I replaced the fuel pump, fuel filter and the pump relay. Started right up and idles forever but will sometimes just quit while driving. After a few minutes and tries cranking, it will start right up. Checked wires and connections and can't find anything out of place.
Any help out there? |
|
#2
|
||||
|
||||
|
Re: Stalling Problem
you might look at the idol air control motor. just had to replace mine in the xj. i was having similar problems.
|
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
| Thread Tools | |
|
|