Mitsubishi GTO

[KaverL]

First off we go to a little paint problem.. I built a subaru WRX, and the paint was shiny and glossy, but when i added clear it became all nudgy, now why did it do that?

Before:

After:


Back on track, the GTO is by tamiya, i painted it red, but its drying right now, so no pics. But i did make the rear suspension. =)

Heres the kit:


And heres the suspension:

[cham2020]

ok
about the subaru.....what was the condition when you sprayed the clear coat. you should have spray under hot weather so that it will not turn color and appaer clear.

[KaverL]

I sprayed the subaru in normal living room temp, 22-25 celsius, in my basement.

[NissanSkylineGTR98]

Nice work on the rear suspension, looking forward to seeing more of the car

[zanthrax]

Try putting the can in warm water a few minutes before spraying.

[KaverL]

Thanks, i will try to put it in water, but how hot should it be? 30 celsius or something like that?

[toyota00]

I have read that you boil water, and then set the can in it for a few minutes? I am not totally sure though.

[KaverL]

Allright, thanks for the tip =)

[INsejn]

It should be so hot that you could put your hand in water without getting hurt. :P

[KaverL]

Maybe i shouldnt boil it then

[cfcrules]

I read about somebody who put it in boiling water and the can exploded so probably not.

[drunken monkey]

although if you do and it does explode, could you take a few photos so we could see the results?

[KaverL]

haha , id like to try it, but i think i better dont..

[KaverL]

The paint weant VERY wrong... al wrinkled and like spiderwebs, although the primer and paint is same manufacturer.. so im gonna get rid of all paint and redo the car =/