|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
08-02-2009, 02:44 PM
|
|||
|
|||
|
1989 Toyota 4x4 Pickup Starter Question (how to get it out?).
I have a 1989 Toyota 4x4 Pickup it’s got a 22RE engine and manual transmission. I have traced my problem starting it down to the starter itself. I went to remove it and could only get to the top bolt. Looking from the bottom I can see the bottom bolt but cant get to it. How do I get that starter out of there without taking half of the passenger side vehicle apart? Can anyone give me a step by step on this, my book has 6 steps like it is simple and its not that simple?
Thanks, 
|
|
#2
08-04-2009, 10:05 AM
|
||||
|
||||
|
Re: 1989 Toyota 4x4 Pickup Starter Question (how to get it out?).
H'mm, for me it's the upper one that is harder to get to. What's in your way ? I'm having a hard time picturing it in my head.
__________________
84 4Runner - ARBed 5.29s F&R, 4.7 & 2.28 t-cases, Chevys, AP x-over, BudBuilt x-member, 2" drv trn lift, 36" TSLs, 30 spline Longs 80 something p/u - Buick 231 V6/TH-350 trans, Holley 4 bbl, Weiand intake, dual batts, dual tanks ... 89 4Runner - stock 2000 Isuzu Trooper + 2010 Sonata
|
|
#3
08-05-2009, 07:53 AM
|
|||
|
|||
|
Re: 1989 Toyota 4x4 Pickup Starter Question (how to get it out?).
The Bottom bolt I could have only gotten with a small air wrench and a long extension the top one I could get with a regular ratchet & I don’t know how I would have gotten the starter out unless I took it out from the bottom but it would have been more impossible to get a new one back in.
GOOD NEWS the top bolt on the starter was loose for some reason and when I tightened it there was a wire going from it to a wire harness. What can I say my vehicle starts like it was brand new! If anyone still wants to post the step-by-step go for it! Thanks,
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
