|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
05-24-2010, 04:20 PM
|
|||
|
|||
|
rear hub assembly change out
I have to change out a rear hub/bearing assembly. Will I need a hub puller to remove the old assembly? I know you need one for the front ones as I have done them before, but didn't know if you also needed the puller for the rear ones.
|
|
#2
06-02-2010, 12:24 AM
|
||||
|
||||
|
Re: rear hub assembly change out
I actually replaced my front right hub assembly with no hub puller. I just disconnected the strut from the hub and the other bolts holding it in place and was able to yank it right off. I don't see why you would need one for the rear, if they're the same as the front....
Just my thoughts :-)
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
