Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys

Stop Feeding Overpriced Junk to Your Dogs!

GET HEALTHY AFFORDABLE DOG FOOD
DEVELOPED BY THE AUTOMOTIVEFORUMS.COM FOUNDER & THE TOP AMERICAN BULLDOG BREEDER IN THE WORLD THROUGH DECADES OF EXPERIENCE. WE KNOW DOGS.
CONSUMED BY HUNDREDS OF GRAND FUTURE AMERICAN BULLDOGS FOR YEARS.
NOW AVAILABLE TO THE GENERAL PUBLIC FOR THE FIRST TIME
PROPER NUTRITION FOR ALL BREEDS & AGES
TRY GRAND FUTURE AIR DRIED BEEF DOG FOOD
Go Back   Automotive Forums .com Car Chat > Dodge > Neon | Plymouth Neon > 1st Gen 95-99
Register FAQ Community Arcade Calendar
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools
Old 11-30-2008, 07:11 PM   #1
dksob81
AF Enthusiast
 
Join Date: Aug 2004
Location: Sharon, Pennsylvania
Posts: 2,746
Thanks: 0
Thanked 1 Time in 1 Post
Send a message via ICQ to dksob81 Send a message via AIM to dksob81 Send a message via MSN to dksob81 Send a message via Yahoo to dksob81
No turn signals/blower motor

I am working on a friends 1996 Dodge Neon and the Turn Signals do not work and the blower motor will not come on.

1). Turn Signals: I checked the FUSE (#6) and it is fine. I then thought it was the flasher - the 4-ways (hazard lights) work fine. Do these vehicles have 2 separate flashers (1 for hazards and 1 for turn signals)? I replaced the Turn Signal Switch and still same problem. The only thing I can come up with is there is a separate flasher for the turn signals and it is not located in the same area as the one for the hazards, located in the fuse block on drivers side of dash.

2). Blower Motor: Soemone told him the Blower Motor Resistor was the problem but he could not find it, so he brang it to me to replace and figure out the turn signal problem. Well I told him usually when the reistor goes bad on most cars you will only have HIGH setting for fan speed. So first I checked the blower motor took it out and manually applied power to the motor and the fan works fine, so I then went ahead and replaced the resistor (located under the cowl) and still same thing. I checked FUSE #7 and the fuse is good. He hasn't drove this car for quite awhile because it had a pretty bad tranny leak and they got a new car and want to use this as a winter beater. Well a few days ago they went to start it and he said soemthing about the alternator being bad and they had that replaced along with the tranny filter and gasket. Now they notice none of this stuff is working - they are not sure if it was working when they had it towed to get worked on or not. The only thing I can think of for the blower motor would be the HVAC Control Unit.

Any Ideas would be appreciated.
Joe
__________________
R.I.P. - 94 Jeep Grand Cherokee Limited 5.2L V8 Quadra-Trac, 3" Budget Boost, K&N FIPK Gen II (Cold Air Intake), FlowMaster American Thunder (Exhaust).

W.T.T.F. - 1998 Jeep Grand Cherokee 5.9 Limited - Deep Slate Pearl - K&N FIPK GEN II (COLD AIR INTAKE), Altezza Tails and Crystal Clear Front end light with HID Kit and NP242 Swap.

dksob81 is offline   Reply With Quote
Old 12-03-2008, 07:32 AM   #2
dksob81
AF Enthusiast
Thread starter
 
Join Date: Aug 2004
Location: Sharon, Pennsylvania
Posts: 2,746
Thanks: 0
Thanked 1 Time in 1 Post
Send a message via ICQ to dksob81 Send a message via AIM to dksob81 Send a message via MSN to dksob81 Send a message via Yahoo to dksob81
Re: No turn signals/blower motor

I found a TSB regarding the blower motor malfunction (TSB# 240397) It says Blower Motor Malfunction in freezing temperatures but it gives no other repair information. Anyone Familiar with this TSB?
__________________
R.I.P. - 94 Jeep Grand Cherokee Limited 5.2L V8 Quadra-Trac, 3" Budget Boost, K&N FIPK Gen II (Cold Air Intake), FlowMaster American Thunder (Exhaust).

W.T.T.F. - 1998 Jeep Grand Cherokee 5.9 Limited - Deep Slate Pearl - K&N FIPK GEN II (COLD AIR INTAKE), Altezza Tails and Crystal Clear Front end light with HID Kit and NP242 Swap.

dksob81 is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums .com Car Chat > Dodge > Neon | Plymouth Neon > 1st Gen 95-99


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 11:40 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts