|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
|
|||
|
|||
|
My sister has a 2000 Durango and the hood cable broke under the hood by the latch... Can someone tell me how to get this open??
|
|
#2
|
|||
|
|||
|
Re: 2000 Durango hood Cable ??
Quote:
From Dodge service manual, Good luck Sorry the PDF file would not copy and paste the picture. Rick LATCH RELEASE CABLE REMOVAL (1) Release hood latch by using the inside release, if still functioning. If not reach up through the bottom of the fascia opening and release the latch pawl lever. (2) Disconnect hood release cable ferrule and cable end from hood latch assembly (Fig. 5) or (Fig. 6). (3) Remove left cowl side trim panel. (4) Remove screws attaching hood latch release cable handle to the cowl side. (5) Remove left wheel splash shield. (6) Disengage release cable from routing clips. (7) Roll carpet back to expose cable. (8) Release taped on cable clip from dash liner (Fig. 7). (9) Release the rubber grommet from the dash panel. Pull cable through the dash panel access hole. (10) Remove cable from vehicle. Fig. 5 HOOD RELEASE CABLE - CONCORDE/300M 1 - HOOD LATCH 2 - HOOD RELEASE CABLE Fig. 4 HOOD LATCH - INTREPID 1 - HOOD BUMPER ADJUSTER 2 - HOOD LATCH 3 - RELEASE CABLE CLIP 4 - NUTS Fig. 6 HOOD RELEASE CABLE - INTREPID 1 - HOOD LATCH 2 - HOOD RELEASE CABLE Fig. 7 HOOD RELEASE HANDLE 1 - RUBBER GROMMET 2 - SCREWS 3 - HOOD RELEASE HANDLE 4 - HOOD RELEASE CABLE |
|
#3
|
|||
|
|||
|
Re: 2000 Durango hood Cable ??
Quote:
Rick |
|
#4
|
|||
|
|||
|
Re: 2000 Durango hood Cable ??
Quote:
TREVOR |
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|