|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Car Modeling Share your passion for car modeling here! Includes sub-forum for "in progress" and "completed" vehicles. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
07-16-2007, 12:51 AM
|
||||
|
||||
|
Best knife blade for cutting very small curves?
Hello,
I'm cutting very tight arcs from styrene and have found that my backward #11 blade is actually too large and clumsy. I would use my BMF panel scriber, but the scriber leaves too much gap (that is, the area it removes is too wide). I'm looking for a knife blade that is both very thin and able to flex a little for use in small places. Does such a thing exist? Thanks Nick 
|
|
#2
07-16-2007, 02:50 AM
|
||||
|
||||
|
Re: Best knife blade for cutting very small curves?
I use a sewing needle in a small pin vice.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
