|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
05-04-2008, 08:17 PM
|
|||
|
|||
|
Gauge Cluster and Check Engine Light?
Hey People....
I have a 2000 Altima GLE / ATX. 60K miles. The gauge cluster briefly stopped working today while I was driving....for about 5 minutes....then it started working again. A few minutes later, the check engine light came on. I just got back from a 400 mile trip, and nothing unusual happened at all....so this kinda makes me a bit concerned. Other than pulling the codes at Autozone (tomorrow), has anyone had or heard of this problem? Thanks for any advice or info!! 
|
|
#2
05-05-2008, 10:48 PM
|
|||
|
|||
|
Re: Gauge Cluster and Check Engine Light?
I went to Autozone today, and the code read that there was basically an intermittent electrical error to the VSS (vehicle speed sensor). I unplugged the harness from the VSS (on the tranny), cleaned off the terminals and reconnected the harness, disconnected the battery for a few minutes (to reset the ECU), and it is now all good.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
