FS in TX:SR20 240sx parts

[cobb420]

I am parting out my 92 240sx. Some parts were installed 2,000 miles ago.
I will sell the car with everything for $5,000 obo if interested. The motor was rebuilt 25,000miles ago. It was bored .20 over with wiseco 86.5mm pistons and Tomei 256 poncams installed. I was having problems with gas getting in the oil so it has a bad rod bearing in cylinder #4 as of last week. New rockers and shims, all gaskets were replaced. 3 angle valve job new guides and seals. Z32 maf, 550cc injectors, redline ecu, nismo fpr, walbro, greddy oil pan, greddy rocker arm stoppers, etc. I will post pictures tomorrow afternoon, I just need to see if any of this stuff will sell. I will do my best to give shipping quotes. I am in Denison, TX 75020.

Thanks,
Jacob
[email protected]

Greddy RS BOV (300miles) $110
Hotpipe w/ greddy flange $55
GT2871R .64 (2,000miles seriously) $900
25mm wheel spacers $90
16x7 & 16x8 Stern 2piece wheels
w/Fuzion 245/45 225/50 tires (2,000miles)$900

VLSD 6bolt nismo 4.1:1 $220
Megan outer tie rods $75 (2,00miles)
Autometer Ultralite Elec. Fuel press. gauge 2 1/16" $150
PLX wideband M250 w/black gauge 2 1/16"(20,000miles) $295
4 Drilled Rotors (2,000miles) $75
GReddy PRofec-B Spec II Black $250
Autometer ultralite oil press. gauge 2 1/16" $25
Greddy oil filter relocation kit $95
Koyo aluminum radiator $150
Perma-cool 14" electric fan w/ adjustable thermostat $140
Greddy Type S BOV $60
MR lightweight pulleys(A/C, Alt., P/S, water) 2,000miles $85
Nismo S-Tune struts 30,000miles $300
Nice Front seats $95
Any parts from the 240 u want $$

May sell the motor and tranny w/necessary parts for $1,800. I will check compression tommorow.

If I part out motor:
Wiseco pistons K556M865 $300
Tomei poncams w/sprockets $300
Nismo FPR $70
Z32 MAF w/plug $125
Greddy oil pan $245
Good Garret T25 $150
550cc injectors 20,000miles $200
Greddy Rocker arm stoppers $50
ECU w/redline chip +chip for race gas $200
Engine Harness w/ Z32 MAF $150
opcorn: