Is this a restrictor?

[jupilerman]

Just wondering. Any of you know if this oil inlet on my T25 is regarded as a built in "restrictor". If not, I´ll have to be buy me one



thanks,
david

[2.2 Straight six]

looks more like a fine "guide" to precisesly direct oil around the bearing.

[Schister66]

what size feed line do you have?? IF you're running -3an, you're fine

[jupilerman]

I haven´t decided on the feed line. Was thinking -4AN though, but -3AN it will be then!

cheers for that!

[KiwiBacon]

Originally Posted by Schister66

what size feed line do you have?? IF you're running -3an, you're fine

What's a -3an?

[jupilerman]

Have a read

http://en.wikipedia.org/wiki/AN_thread

[jupilerman]

Just for sake of completeness. AN Stands for Airforce Navy. the AN size is derived by multiplying the nominal (internal?) size of a hose by -16. So 1/2" hose equals 1/2"*(-16)=-8AN

so in my particular case -3AN equals a hose with internal diameter of 3/16"=0.1875"=4.7625mm

anybody can confirm?
cheers,
david

[KiwiBacon]

Originally Posted by jupilerman

Just for sake of completeness. AN Stands for Airforce Navy. the AN size is derived by multiplying the nominal (internal?) size of a hose by -16. So 1/2" hose equals 1/2"*(-16)=-8AN

so in my particular case -3AN equals a hose with internal diameter of 3/16"=0.1875"=4.7625mm

anybody can confirm?
cheers,
david

So it's a pointlessly complicated way of measuring something in 16ths of an inch?

I can't see the application of MIL standards to automotive.

[2.2 Straight six]

this is why you guys need to fully adopt the metric system.

i'm not anti-imperial or anything, but metric is soooooooo much easier to work with.