|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
10-29-2006, 04:40 PM
|
|||
|
|||
|
removing stud on head that holds valve cover
i got my replacement motor and i realised that one of the studs was snapped off that stick out of the head to the valve cover i dont want it to leak oil. anyone know if the stud is replaceable and if so how to get it out?
|
|
#2
10-30-2006, 07:37 PM
|
||||
|
||||
|
Re: removing stud on head that holds valve cover
http://www.mytoolstore.com/hanson/extractr.html
You need a screw extractor. You drill a hole down the center of the stud bolt, and then use the extractor to "unscrew" it from the block. New stud bolts are available from BMW. Good luck!
__________________
ShadeTreeBill 1989 525i Cirrus Blue Automatic 2002 White Malibu (wife's car!) shade tree mechanic - an amateur or otherwise marginally competent mechanic who primarily works on cars out back under a "shade tree" which serves both to provide a cool place to work, and a handy tree limb to attach the block and tackle to remove the engine.
|
|
#3
11-02-2006, 10:37 AM
|
|||
|
|||
|
Re: removing stud on head that holds valve cover
a friend of mine did it for me and it worked great no re tapping needed or anything. old motor is almost out of the car today i have to take out the 3 torque convertor bolts and the 2 motor mounts and its coming out.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
