|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Car Modeling Share your passion for car modeling here! Includes sub-forum for "in progress" and "completed" vehicles. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#2
07-31-2006, 12:37 PM
|
||||
|
||||
|
Re: Rollpan for an S-10?
why buy one when you can take 5 minutes and bend some styrene and make one?
__________________
-Josh- 96' Integra GSR / ITR cams/valvetrain. Skunk2 IM, Greddy evo2, AEM CAI, RMF Header, Megan testpipe, Hasport mounts, Eibach coilovers, Beaks tie bar, Megan H brace, Rota Attacks, F/R strut bar, Kirk 6 point cage, Bride Cugas, Takata 4 Point, ITR Steering wheel 98' SVT Contour, 3L Port-Matched swap with SVT cams/full bolt ons; 224fwhp. 01' Chevy Blazer, DD. 
|
|
#3
07-31-2006, 02:43 PM
|
||||
|
||||
|
Re: Rollpan for an S-10?
for which kit are you talking about. The AMT 93-97 S-10 kits, or the Revell/Monogram 83-92 kit. it would be easy to do on the Monogram kit, just get the Cyclone kit that Monogram did. it comes with a flat roll pan.
somebody used to produce a roll pan for the AMT Silverado. it had Corvette tailights in it. with some work that could be mated to an S10. but I agree with pre98zetec. its easier just to make one yourself.
|
|
#4
07-31-2006, 04:14 PM
|
||||
|
||||
|
Re: Rollpan for an S-10?
I still haven't gotten details on wether or not it has a licence plate recess or any lights, or if it's completely smooth. Certainly if it's completely smooth I can fab my own rather easily.
And ya, it's a boxy, so I guess the Syclone kit would work. Thanks.
__________________
   
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
