|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
03-14-2006, 06:44 PM
|
|||
|
|||
|
Lid is driving me nuts
Ok so i just got the new SLP air lid for my car. Everything went smoothly until i hit a bump. How the hell do u "loosen the worm screw cap on the throttle body" is it that lil ring kinda thing. And 1 more question. They tell you to remove the negative battery terminal
 I didnt know this was needed. And do you have to loosen the 3 plugs also. The MAF,ATI, and there's this other one to. HELP
|
|
#2
03-14-2006, 06:46 PM
|
||||
|
||||
|
Re: Lid is driving me nuts
ATI?
You lost me. The 'ring' I believe you are talking about should be about 3-3.5 inches around. Actually a clamp. Use a flathead to loosen it. To remove just the lid?? Only the IAT sensor needs removed. MAF can stay on the MAF...unless you are removing that. Pics of the problem areas might help. 
__________________
1999 Pontiac Trans Am WS.6 #1747 Stock'ish'
|
|
#3
03-14-2006, 06:59 PM
|
|||
|
|||
|
Re: Lid is driving me nuts
IAT thats what i meant. But the directions on intalluniversity and the SLP sheet are totally differant. Did u have to remove you neg battery termianl Luos??
|
|
#5
03-14-2006, 08:03 PM
|
|||
|
|||
|
Re: Lid is driving me nuts
Can i just use the installation tips on install university. They seem a little easier and actually show you pics. Are the whisper lid and the SLP the same installation basically. What would you guys suggest.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
