|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
12-17-2005, 09:05 PM
|
|||
|
|||
|
1993 Wrangler clutch master cylinder
Can anyone help me find a clutch master cylinder, line, and slave cylinder? I've been told by my local Jeep dealer that the parts will take up to 6 weeks to get. Are these not commonly stocked items?
Thanks for any help. 
|
|
#3
12-18-2005, 02:11 PM
|
|||
|
|||
|
Re: 1993 Wrangler clutch master cylinder
Quote:
I'm really in a jam, thanks
|
|
#4
12-19-2005, 09:09 AM
|
||||
|
||||
|
Re: 1993 Wrangler clutch master cylinder
if it's like my 93, then you'll need a hydrolic throw out bearing, not a slave cylinder.
__________________
when all else fails, get a bigger hammer.  Vehicles: 2005 suburban 1500 4x4 all stock, ex-fire department truck. 1987 Grand Wagoneer
|
|
#5
12-19-2005, 08:36 PM
|
|||
|
|||
|
Re: Re: 1993 Wrangler clutch master cylinder
if you have a little extra cash i would just buy a clutch kit. comes with everything you will need, except for the line maybe. the upside is that you will be able to replace the clutch plate while you tear everything apart so that you dont have to worry about needing to go back and do it all over again in a year if the clutch goes bad. and yes it is a hydraulic throwout bearing. like i said though, the downside is that you wont get the line to bleed the clutch. to get this from a dealer you will have to buy a special clutch kit and it will cost you an arm and a leg. never buy from the dealer, quadratec all the way. peace
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
