 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Dog Food | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
11-15-2005, 08:52 PM
|
#1 | |
|
AF Newbie
Join Date: Nov 2005
Location: winfield, Tennessee
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
exchanging motors
First time user needing some advice. I have had a friend replace the motor in a 94 lumina z34. It was replaced with a 94 pontiac motor. After the motor was set down in the lumina it was then noticed that the lumina did not have a crank shaft positioning sensor and the pontiac motor does. The wiring harness in the lumina does not have a wire for the sensor. Does anyone know of a fix for the problem short of pulling the motor back out and getting a motor out of a lumina instead.
|
|
|
|
|
11-15-2005, 09:50 PM
|
#2 | |
|
In God We Trust
 
Join Date: Nov 2003
Location: Maple Lake, Minnesota
Posts: 5,971
Thanks: 4
Thanked 24 Times in 23 Posts
|
Re: exchanging motors
The motor's have to both be the same, I'm guessing the lumina z34 was a 3.4 dohc, and the pontiak was a 3.1? The only way to do this correctly is to get all the wiring and computers from the donar car. Hop on over to http://www.60degreev6.com There is a lot of good information over there about engine swaps.
__________________
-2000 Grand Prix GTP 170,000mi (daily driver) -2000 Olds Alero 100,000mi (soon to be DD with gas at $3.45/gal) -1997 Chev K1500 4x4 115,000mi (Natalie's truck [nans_grandprix]) AF "2.0" Community Guidelines Conservative Victory 2012!!! "I'll Keep my Guns, Freedom, and Money. You can Keep the Change!" ----->>>>> Did You Know? <<<<<----- |
|
|
|
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
