|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
10-23-2005, 11:16 AM
|
|||
|
|||
|
3.4 sawp to 4.3
my camaro has almost 200k on it so i dont think its going to last much longer i hav an 4.3 s10 motor and tanny with about 30k could i put that in my camaro what all would i would i have to do so that every thing works fine or should i just get new 3.4
thanks ahead 
|
|
#2
10-23-2005, 11:21 AM
|
||||
|
||||
|
Re: 3.4 sawp to 4.3
what tranny do you have with the 4.3? Its definetly possible and well worth it if you already have a 4.3 lying around.
__________________
92 z28 camaro 5.7 TPI current - slp intake runners and base-BBK 52mm throttle body-MSD 8.5mm wires, blaster coil, and 6AL Box-edelbrock headers-160 degree stat.-hotchkis strut tower brace waiting in the garage - LQ4, milled heads 317 casting (10.5 to 1), hardened pushrods, ported LS6 oil pump, manley dual spings with titanium retainers, MTI X1 cam, hawks longtube headers 
|
|
#3
10-23-2005, 11:28 AM
|
|||
|
|||
|
i think its a nv3500 i cant think of it off the top of my head but do u no if i have to do anything to the car or can i just sawp them and go
|
|
#4
10-23-2005, 12:01 PM
|
||||
|
||||
|
Re: 3.4 sawp to 4.3
that 4.3 tranny probably isn't set up for an f-body suspension (torque arm and mounting locations) you'd either have to find some way to modify it to fit or perhaps the tranny from the 3.4 will fit the 4.3.
__________________
|
|
#6
10-23-2005, 05:36 PM
|
|||
|
|||
|
no the 4.3 will not bolt to the 3.4 tranny.......the 4.3 is a 90 degree motor and the 3.4 is a 60 degree....different bolt patterns
__________________
1984 Camaro 5.7L 350 700R4 Holley 650 Cfm Edelbrock Performer Intake-Manifold Crane Cams Duration @ .050": 204/214 Lift:420/442 Summit HEI Distributor Hedman Shorty Headers Hedman Y-pipe Dynomax Turbo cat-back NOS Decal VTEC Decal
|
|
#7
10-23-2005, 06:28 PM
|
||||
|
||||
|
Re: 3.4 sawp to 4.3
I believe putting the 4.3 in will take same modifications as putting a 350 in (since they are the same, just minus 2 pistons).
Also, what year of s10 is that engine comming out of? If its a later model 95+ i believe it would have the 4L60E tranny, or if its older, it will have the 700R4 Good luck -Ryan
|
|
#8
10-25-2005, 01:49 PM
|
|||
|
|||
|
Re: 3.4 sawp to 4.3
That would be a good swap without a lot of clearance issues. Not to mention the power potetial for the 4.3.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
