|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| '88 - '91 Civic | CRX | Wagon | Shuttlee Partnership with: LadyNRedSi.com |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
10-10-2005, 06:13 PM
|
||||
|
||||
what dizzy do i need
ok so im still looking for the mpfi conversion stuff blah blah blah. well i foudn a 6th gen intake mani wiht wire harness from a y8 motor. would i need to use a obd2 dizzy or can i get away with soemthign else. as well what ecu would i use.
__________________
06 cbr 600 f4i 91 civic hatchback. 96 nissan pathfinder 
|
|
#2
10-10-2005, 07:18 PM
|
|||
|
|||
|
Re: what dizzy do i need
are you going to go obd0 or what. If your going to go obd0 you need a dizzy off of a d16a6 si motor.
__________________
Got the car 1400 Need an H22a4 4000 Some Goodies to go Along With it 2000 Some Drag Slicks 750 Going to the Strip and Make V8's Say D*** Hondas PRICELESS
|
|
#3
10-11-2005, 12:26 AM
|
||||
|
||||
|
Re: what dizzy do i need
well i foudn a manifold and wire harness but its from a 6th gen honda which were obd2 so im wondering if i need do that. becuase the mani and wire harness are like 85
__________________
06 cbr 600 f4i 91 civic hatchback. 96 nissan pathfinder
|
|
#4
10-11-2005, 02:50 AM
|
||||
|
||||
|
Re: what dizzy do i need
you can use any OBD0 dizzy. trust me.
__________________
2004 Toyota Tacoma 4x4 1990 Eagle Talon TSi AWD 2002 Suzuki GSX-R 600
|
|
#5
10-12-2005, 09:29 AM
|
||||
|
||||
|
Re: what dizzy do i need
the obd dizzy wont bolt right up...you might have to open up the bolt holes so you can blot it on...that should be the only problem. its just the offset...
__________________
_________________________________http://VelocityFactor.com________________________________ 1990 si hatch b20b si tranny megan race header 2.5 custom exhaust 50 shot integra da rear disk (w/ 4040 valve) powerslot rotors and barded lines all around 1994 Dx hatch stock
|
|
#6
10-13-2005, 05:11 AM
|
|||
|
|||
|
Re: what dizzy do i need
if your just swapping intake manifolds, which has nothing to do with the distributor. the distributor is on the head not the intake manifold so if you want to stay obd0 use a si distributor. you wont even need any plugs from that y8 harness unless your going with vtec. wait you will need the obd2 injector plugs if you are using obd2 injectors. every other stock sensor on your motor plugs right up. might have to extend tps and iacv and map but youll see how it goes.
so just do the regular mpfi swap
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
