|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
08-30-2005, 03:39 AM
|
|||
|
|||
|
98 Cherokee Power Door Lock switches not working
I bought a 98 Cherokee Limited from an auto wrecker and repaired it so I'm not sure who the original owner is. Neither the driver or passenger door lock switches work. I have checked Fuse 15 and Circuit Breaker 28 and they are both good. However, if I disconnect the battery cable and then reconnect it, the doors all lock immediately (almost locked my only key inside) so I know all the lock solenoids are working. How can I tell if this has keyless entry? I downloaded the 2000 FSM (both downloads) but they are missing the Section 8A through 8V, goes from 7 to 8W. Anyone know where I can get those?
|
|
#2
09-12-2005, 02:06 AM
|
|||
|
|||
|
Since no one responded yet and I solved the problem, I will post my own reply. Turns out the culprit was the passenger side lock/window switch. It was providing +12 volts on both inputs to the door lock motors. With a replacement switch installed, both inputs are at ground. BTW it was also draining my battery which doesn't happen anymore.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
