is there supposed to be an air readout on safc II?

[HoosierDrifter]

ok... car still running rediculously way too rich.... i noticed going through the monitors on the safc II that its not reading anything for air... is this normal? or should it be reading somthin?

[nissanfanatic]

There should be an airflow %, Throttle%, RPM, and correction%, and you should even have a knock display. Make sure you select the highest number of channels to get as many readings as possible. And in sensor check, there should be in-1 voltage and in-2 voltage as well as TPS voltage.

I have never used the SAFC 2, but I use the SAFC all the time. When Tat gets on, he should be able to hook you up with some more accurate info.

[HoosierDrifter]

hmm well... i have hooked everything up correctly... and it shows rpms and throttle % but when i go to "afl" it reads nothing..just stays at zero... i have tried two different mafs.... nothing... im about to hook up my stock 240sx maf and see what that does.

[nissanfanatic]

You have it wired wrong...

SAFC install This is for the SAFC 1, but it will still show where to cut and solder the air flow meter wire.