swap help

[BlazeD0ut06]

hey guys..
ok so im in the process of swapping my dogshyt for a jdm gsr swap..so i'm gonna have some stupid questions on the way..
i need wiring help..
i have the breakdown from ffsquad as far as the wiring of vtec iat and crap goes...
but where do the other ends of these wires go?
pics are a plus...

also any way to break off this POS axle nut?
i spent all morning trying to loosen the bitch...

[jcrx]

Take it to a shop with a high PSI impact gun break it, and than put it on gopod enough to gety back to where you are doing the swap, but so you can still get it off, about 80lbs should do it. Make sure you have indentation pushed up too.

http://www.hondaswap.com/forums/inde...howtopic=41608

for wiring

[_93civchatch_]

Originally Posted by jcrx

Take it to a shop with a high PSI impact gun break it, and than put it on gopod enough to gety back to where you are doing the swap, but so you can still get it off, about 80lbs should do it. Make sure you have indentation pushed up too.

http://www.hondaswap.com/forums/inde...howtopic=41608

for wiring

you could also try using some penetrating oil and then using a big bar to put on the end of the ratchet or wrench. whichever your using for leverage