|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Car Modeling Share your passion for car modeling here! Includes sub-forum for "in progress" and "completed" vehicles. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#2
04-27-2005, 12:28 PM
|
||||
|
||||
|
Re: Bubbles inside decal
use a needle to make a small hole in the buble and use microsol to soften it
__________________
 CarsModeling.com. My Scale Model Cars blog. 
|
|
#3
04-27-2005, 03:37 PM
|
||||
|
||||
|
Yeah, put a drop of decal solvent over the bubble, pop it with a very sharp knife or pin, the smaller the hole the better, wait a few seconds for the solvent to draw in, and carefully blot the moisture out so the decal is flat and let it fully dry before touching it again... - Mark
|
|
#4
04-28-2005, 08:46 AM
|
||||
|
||||
|
Re: Bubbles inside decal
I thought that Microsol melted the tamiya decals!?
__________________
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
Bubbles inside decal
