 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
04-01-2005, 04:31 AM
|
#1 | |
|
AF Newbie
Join Date: Apr 2005
Location: Albion, New York
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
|
'92 blazer ignition module
Okay out there, how do I change the ignition control module on a '92 Blazer 4WD 4.3 V6 TBI Engine? I've searched the forum and found nothing so far...So I thought I'd ask...
|
|
|
|
|
04-01-2005, 07:43 AM
|
#2 | |
|
AF Enthusiast
 
Join Date: Jun 2003
Location: Pittsburgh, Pennsylvania
Posts: 3,549
Thanks: 0
Thanked 1 Time in 1 Post
|
Unplug the wires at the distributor, remove dist cap. Remove rotor. remove both 7mm screws on module, lift out. Replace in reverse, put about a 1/4" layer of dialectric grease on the bottom of the new module. (Or you will be replacing the new module in a month due to heat damage)
__________________
  95 s10 Blazer, EGR Mod, ZQ8 Steering box mod, 99 Center console shifter mod and more... See everything at www.pghconsulting.net/teal |
|
|
|
|
|
04-01-2005, 11:39 AM
|
#3 | |
|
AF Newbie
Thread starter
Join Date: Apr 2005
Location: Albion, New York
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
|
thank you very much!! It worked!! Just so I would know though, how could you be able to tell if the coil went as opposed to the module?...
|
|
|
|
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
