-
Grand Future Air Dried Fresh Beef Dog Food
Air Dried Dog Food | Fresh Beef

Carnivore Diet for Dogs

Go Back   Automotive Forums Car Chat > Honda > JDM Motor & Parts info/chat
Register FAQ Community
JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info!
Reply Show Printable Version Show Printable Version | Subscription Subscribe to this Thread
 
Thread Tools
  #1  
Old 12-21-2004, 10:44 AM
ATL_boi ATL_boi is offline
AF Newbie
 
Join Date: May 2004
Posts: 10
Thanks: 0
Thanked 0 Times in 0 Posts
Help w/ changing belts on 93 Accord

the two belts on the side of the motor (not sure the names of them). The out side one broke, went to replace it and saw that the other one is pretty bad also. I have to book and it shows how to do the outside one but the inner belt I don't see any bolts to adjust and remove (or do the same bolts adjust both belts)?
Pleeease help.
Reply With Quote
  #2  
Old 12-21-2004, 02:58 PM
Blazedout06 Blazedout06 is offline
Banned
 
Join Date: Aug 2003
Posts: 53
Thanks: 0
Thanked 0 Times in 0 Posts
Send a message via AIM to Blazedout06
Re: Help w/ changing belts on 93 Accord

umm...hehe..


the one inside is probably ur timing belt...
and if it is..i would suggest strongly that u do not touch it...

i would say take it to the shop and have that fixed..

if u get the timing wrong ur car will not run right!!!
Reply With Quote
  #3  
Old 12-21-2004, 05:44 PM
superbluecivicsi superbluecivicsi is offline
AF - Advisor
 
Join Date: May 2003
Posts: 3,039
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Help w/ changing belts on 93 Accord

power steering and ac. i believe the one you cant get to is the ac. im not sure where it is on an accord, but, like any others, there is an ac tensioner pulley. follow that pulley and search around (it moves the ac belt up and down) to find a bolt to adjust the tensioner and a different bolt that holds it in place. loosen the bolt that holds it in place and then loosen the adjusting bolt.

this is a civic/integra specific question, locations may vary, but the concept is the same on all vehicles.

PS: on civic/integra applications, you cant get to these bolts without removing the power steering unit. its also a very tight squeeze.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov.
95 HB- B16a2- SC34@12psi
WTB: USDM B16a2 or B16a3 complete short block. pm is the key.
FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums Car Chat > Honda > JDM Motor & Parts info/chat


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 12:33 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts