|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
12-10-2004, 06:13 PM
|
|||
|
|||
|
How do I adjust my timing?
Hey, me again. I have a 1991 Chevy S-10 Blazer 4x4, 4-door, 4.3L engine. I just put a new motor in and replaced most parts. I am wondering how do I adjust the timing on my motor. I know how to check it, I just don't know how to adjust it. I heard that I have to turn the distributor? If anyone can reply with more indepth information I would really appreciate it. Thank You everyone.
|
|
#2
12-10-2004, 07:21 PM
|
||||
|
||||
|
Disconnect the distriibutor from the ECM (tan wire under the passenger side carpet against the firewall) Loosen the dist bolt, time to 0 degrees TDC then lock down dist.
__________________
  95 s10 Blazer, EGR Mod, ZQ8 Steering box mod, 99 Center console shifter mod and more... See everything at www.pghconsulting.net/teal
|
|
#3
12-10-2004, 08:47 PM
|
|||
|
|||
|
Re: How do I adjust my timing?
How do I get it adjusted to 0 degrees though? Isn't there something to where I can "tweak" to get the timing to zero?
|
|
#4
12-10-2004, 09:21 PM
|
||||
|
||||
|
Re: How do I adjust my timing?
Yes, loosen the distributor bolt, run the engine with a timing light, rotate the dist left or right until timing is proper, stop engine, tighten bolt, reconnect tan wire under carpet, close hood
__________________
95 s10 Blazer, EGR Mod, ZQ8 Steering box mod, 99 Center console shifter mod and more... See everything at www.pghconsulting.net/teal
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
