|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
11-29-2004, 12:45 AM
|
|||
|
|||
|
3.2L DOHC isuzu V6 motor valve clearance
In the service manuals for these motors there is a valve adjustment at 60k miles/ 100k km. I believe it's done by adjusting shims. Has anyone done this themselves or is better to have the experts do it. And is it essential to do? Anyone done it and noticed better performance after?
|
|
#2
11-29-2004, 01:21 AM
|
|||
|
|||
|
Valve lash adjustment on the 1998+ 3.2/3.5 sounds like a royal PITA. You can flip over & reuse the shims. General consensus is leave'em alone unless you get a steady, constant tick. Check this post: http://forums.delphiforums.com/itog/messages?msg=2653.9
Jerry gives some real good info. G/luck Joel
__________________
2016 Subaru Forester 2.5i base CVT 2016 Nissan Quest SV
|
|
#3
11-29-2004, 07:29 PM
|
||||
|
||||
|
Re: 3.2L DOHC isuzu V6 motor valve clearance
This Is Not A Do It Yourself Job Unless You Have Some Serious Experience
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
