|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
07-14-2003, 12:59 PM
|
|||
|
|||
|
Distributor Cap and Rotor on my 94 Integra
Is there a trick to getting the rotor off of my distributor on my 94 Integra LS? Most rotors I've seen just pull off but this is the first time I've tried to replace the cap and rotor on my Integra. Is it stuck or am I doing it wrong.
|
|
#2
07-14-2003, 02:34 PM
|
|||
|
|||
|
Thanks guys. I bought a new rotor over lunch and figured out the problem. There is a hole in the back of the rotor where I assume some sort of set screw goes. I had the rotor turned around the other direction last night when I was trying to take it off so I couldn't see it.
|
|
#3
07-24-2004, 04:36 AM
|
|||
|
|||
|
Re: Distributor Cap and Rotor on my 94 Integra
Were you able to get the screw off easily?
__________________
1994 Acura Integra GS-R Performance Mods: AEM Intake DC Sports Headers GReddy Cat Back Exhaust Ground Control Coilovers Exterior Mods: WW Body Kit PIAA Low Beam Bulbs '98 Style Integra Taillights
|
|
#4
07-24-2004, 11:02 AM
|
||||
|
||||
|
when i took my rotor off, that screw was on there pretty tight. i had to use alot of force to get it off. i actaully snapped the head off of one of my screw drivers try n to take the screw off. but the screw driver was a cheap low quality one.
__________________
www.MEDIUMRACING.com 
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
