Need Help

[YZ125rider21]

I am trying to pull axel but it aint ocming out easy. trying to pull the block with tranny but cant get it out till axels are off.. I unbolted the axels bolts with a 32mm but thats all i know from here...so one can give me some advice getting them off be nice thanks

[TheSilentChamber]

theres a tool you can buy/rent to do it with. Kinda like a gear puller. If you have an Autozone in your town you can get it from them with a deposit, take it back and you get all your money back.

[91civichatch2571]

to take out the axkes, you gotta take that 32mm nut off (already done) undo the outer tie rod, and take the nut off the lower ball joint so you can seperate them. The ball joint probly wont just pop off, you will need to hit the hub where the ball joint goes through with a hammer to knock it loose. After those are unbolted, your whole hub will be able to move all around nice and loose. Then you gotta get under the car and stick a screwdriver in between where the axle meets the tranny and wedge it in there so the axle pops out. easy as pie.

[YZ125rider21]

thanks i got it done

[2ndb18]

ya some are just hard to get off, old ones