|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Remote Control Cars Questions, comments or discussions on the wonderful little vehicles. |
![]() |
Show Printable Version |
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
|
|||
|
|||
|
this is from a defiant site and was thinking for doing some of them
#3, 4, 5, 6, 7, and 8 what ones would you say are a good idea to do? plz list which one's are a yes and which one's are a no. if no plz say why. thank you http://pub238.ezboard.com/fxmodrcfrm...opicID=6.topic |
|
#2
|
||||
|
||||
|
okay about number 3 i dont understand what the guy is tryig to say but i think he wants to stifen the suspension. thats not a bad idea thats what they do on real cars for more preformance. the bad thing about his idea of compresing the springs so there harder is that u get less suspension travel =ing worse preformance over bumps. its better to buy the suspension kit from Xmods. What would be even cheaper is to take springs from a pen and adapt them to ur xmod. ( i dont own one so im not 100% sure u can do that, I plan to get one though
). number 4 is a good idea unless those are important structural pieces. I wouldn't do it unless u race and u need every little edge u need. a better engine is good and it would give u more power. But only do his mod if ur a 100% sure of ur abilities and the products u have. ( If u dont own a soldering iron it will probably be cheaper to just buy the Xmods engine). Number 6 sounds good but dont use silicone hose use metal shims ( about 1 mm each). What most RC guys do to get a perfect mesh is stick a sheet of paper inbetween the gears and then mesh them. this give a perfect mesh. For number seven again use metal shims instead of silicone hose. the ball bearings are a great mod. just dont buy the "Oficial ones" go to the local hoby shop and buy the ones u need. none of these mods seem to put ur car at any permanet risk. So go for it if u feel confident.
|
|
#3
|
|||
|
|||
|
i did #2 and #4
#2 just took off the shaft and now it will not go in reverse half the time but forward it is just fine #4 was good and did not do a damn thing but so i am not going to put it back on i did Shim the lug nuts just in the front and seams to help all in all what i did was just some thing to do for a few min no real defiance in any thing |
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|