|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| '88 - '91 Civic | CRX | Wagon | Shuttlee Partnership with: LadyNRedSi.com |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
09-11-2003, 10:52 PM
|
||||
|
||||
|
ZC trans compatibility
Hey all, I am planning on using this ZC tranny for my new crx, and planning on putting in a Z6. My question is, are there holes on the back of the Z6 block for the intermediate shaft to attach? If so, are there already threads, or are they unthreaded? I have heard that some have to be tapped, anyone have experience with this?
 Thanks!
__________________
Remember: You can't spell Crap without APC! Classic SE-R GTi-R turbo setup 3" DP U12 modified ECU Hyperco GenII suspension Progress sway SAFC etc. etc. 
|
|
#2
09-12-2003, 06:57 AM
|
||||
|
||||
|
I don't know if the ZC Intermediate Shaft would bolt up to the Z6. But I believe for the ZC tranny you have to use the Intermediate Shaft since the imput holes are bigger than the other L3s. So if you can't get the intermediate shaft to work than you can't get the ZC tranny to work.
__________________
http://www.fourthgenhatch.com FOR SALE: Get this stuff out of my house! -Stock hood (red) $30 -Stock Rear Spoiler (red) $30 -Stock mirrors $30/both -Stock side front and rear side glass $30/piece
|
|
#3
09-12-2003, 05:52 PM
|
||||
|
||||
|
some d16's came with the holes for the intermidiate shaft...although they need to be tapped.
__________________
so whats wrong with a d15b2 again?
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
