|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
| Latest | 0 Rplys |
|
|||||||
![]() |
Show Printable Version | Email this Page |
Subscribe to this Thread
|
|
|
Thread Tools |
|
|
#1 | |
|
AF Newbie
Join Date: Jun 2010
Location: cleveland, Ohio
Posts: 51
Thanks: 2
Thanked 1 Time in 1 Post
|
Correct ABS resistance reading
My 2002 Malibu needs a Bearing hub with the anti locking break sensor built in to it. I need to check it with my ohm meter to see if it is the right front or left front sensor that is bad. Dose any one know what the resistance reading should be on these sensors?
hotpipes |
|
|
|
|
|
|
#2 | |
|
A990 racer
![]() Join Date: Mar 2002
Location: Chestertown, New York
Posts: 17,051
Thanks: 26
Thanked 383 Times in 374 Posts
|
Re: Correct ABS resistance reading
Around 1150 ohms at room temp.
__________________
|
|
|
|
|
| The Following User Says Thank You to maxwedge For This Useful Post: |
hotpipes (06-27-2011)
|
|
|
#3 | |
|
AF Newbie
Thread starter
Join Date: Jun 2010
Location: cleveland, Ohio
Posts: 51
Thanks: 2
Thanked 1 Time in 1 Post
|
Re: Correct ABS resistance reading
I have checked the right and left ABS sensors the right reads 1135 and the left reads 1104 the right one is about 27 months old and the connections are shine clean on both of them I checked the break fluid and that is up to max. Do you think that left one reads to low and needs to be replaced?
hotpipes |
|
|
|
|
|
|
#4 | |
|
AF Newbie
Thread starter
Join Date: Jun 2010
Location: cleveland, Ohio
Posts: 51
Thanks: 2
Thanked 1 Time in 1 Post
|
Re: Correct ABS resistance reading
Since we talked last I had the the ABS scaned and found that the right front sensor with bearing was not giving the pulls needed to turn off the light. That bearing and sensor is just over two years old. I guess even with a good resistance reading the sensor can be bad
hotpipes |
|
|
|
|
| ||||||||||||||||||||||||||||||||||||||
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|