|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
09-18-2010, 10:56 AM
|
|||
|
|||
|
No Start
04 XC90 T6. just replaced the turbos and now will not start. I found the there is no injector pulse. I have full fuel pressure and all spark plugs are firing. Scaned the vehicle and found fault U0002 high speed CAN communication BUS performance. the only info i can find is that is Control module internal fault. Faulty signal. permanent fault.
Dose this mean that my ecm is not providing the injector signal because its faulty? Any help would be great Thank Tim 
|
|
#2
11-02-2010, 01:54 PM
|
|||
|
|||
|
Re: No Start
Well I know its been awhile and didn't get any help from anyone on here, due to it being such a weird problem. Figured i would post the results. found the CEM was taking out the CAN bus. not sure why it started after i had the turbo out. but anyway. replaced with a junk yard module and it fired right up. After doing a search for CEM's on google i found a few post, q/a about how they can be a common problem. Anyway hope this helps anyone out in the future. Thanks
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
