Profile HA1000 2ch VS. Profile CA600

[balls_to_the_wall]

Ok, I'm wondering here...Do I go with the Profile CA600 (which you guys recommended) or do i go with the Profile HA1000, which is 10 bucks cheaper, and puts out more power....Im thinking the more power and less money, cause my motto is "If its worth doing, its worth doing in excess"....Just wondering

-Thanks Alot guys

P.S. THis should be my last question, and I will post on how it all sounds when I get all the stuff ordered and installed...GOD i hope the guy buys my current subs....!!!!!!!

[bumpinstang77]

for an SE you'll need to either go 4 channel or mono.

[balls_to_the_wall]

I was feeling Mono channel....would this work out fine then?

[bumpinstang77]

yea............ you need your power at 2 ohms 8 ohms or 2 seperate 4 ohm loads.

[balls_to_the_wall]

Which would be louder, Mono at 2 ohms, or 1 channel for each voice coil at 4 ohms????

[bumpinstang77]

The same with the same power.

[ngsm13]

Neither...personally, I won't touch any profile except the Clarus series. Spend the extra few bucks on ebay and go with a CL800 or something.

I've had numerous bad experiences with the BA, HA, AP/CA lines. My buddies BA/HA went back to profile THREE times within a year, and finally bit the dust. The clarus line tho, I've had two friends bumpin them for over a year no problems. I've also installed plenty of the CL line...woot

NG

[threedd97]

I bumped a 600W Kenwood for 4 years... with 2 10" Orion Cobalts.

[bumpinstang77]

yea I've had no problems w/ the ca/ap line.....hmmmm yea those or te CL line should be fine.