Amp for 4 12's

[GCguy2169]

What would be the best amp to buy for under $300 bucks, to push 4 400RMS 12's?

[Haibane]

get 2... you will want it, but under 300... try the nine.1 it is about 278 shipped

[loismustdie]

how about a jbl 1200.1, that will give 300 watts to each sub if its wired correctly, and will get hella loud

[Haibane]

the nine one aught to give a little more than 300 per sub... also, what is the impendence on the subwoofers?

[sr20de4evr]

PG 1200.1 would work too

Nine.1 might not, depends on the impedence of the subs

[GCguy2169]

The subs are DUAL 4-ohm. 400 R.M.S. a piece. Built my box today (June 15) about 8.3 cubes in all, 4 4 inch square ports tuned to 35 Hz. Should Bang?? Fixin' to get me an amp, lemme know...

Remember DUAL 4-ohm.

btw- I was thinkin since I'm on a very strict and tight budget, maybe some profiles. Some of them put out about 300 RMS x 2, at 2 ohms. If i got 2 of them, it would cost me about....$160 shipped? Good deal, good quality?

[sr20de4evr]

hmm, so you have 8 4ohm coils....

lets see, you can get .5ohm, 2ohm, 8ohm, 32ohm, and probably some other insignificant ones in between, the point being you cannot get 1ohm, so the nine.1 wouldn't work. JBL 1200.1 or PG 1200.1 get my vote.

[GCguy2169]

What sites, and where can I find these amps at? What do they run? What do u think about the box?

[sr20de4evr]

Not a clue on the box, the box design depends completely on the subs that are going to be used in it.

Anyway, for the amps try www.woofersetc.com and ebay

Profile amps are pretty solid, but honestly they're still very low budget amps. I would go with JBL or PG instead if you can afford it, if you can't then the Profile should be fine, stick to the California line though.

[bumpinstang77]

go with two seperate amps that will put out around 5-600 rms at 1 ohm or 4 ohms.....I wouldn't be comfortable putting those x-sites at full power. Perhaps two bx500d's or one bx1500d @ 2 ohm.